10.11.2016
Cleveland US Indoor Champs as picked SXT 3.0 again as the official handout traction compound! The race is moving to a new venue this year and looks great!

10.8.2016
SXT has once again signed on board to the be the official traction compound of the Halloween Classic!

10.1.2016
The IIC race in Las Vegas by Scotty Ernst was back this year! SXT 3.0 was selected as the official traction compound again! It was a great week of racing in the new venue with a larger track!

1.30.2016
We are proud to launch SXT 3.0 Lite at the Snowbird Nationals! 3.0 Lite was developed to cut down on the aggressive feeling that occurs on high bite carpet racing, especially with the new black carpet release by CRC this season. Pick up a bottle with the chrome dot on the cap!



Distributed By:
Contact Us:

info@tractioncompound.com






SXT 3.0 Lite
SXT00035

SXT 3.0 was designed to provide superior performance in a minimum odor environment for both foam and rubber tire racing.

3.0 Lite was developed to cut down on the aggressive feeling that occurs on high bite carpet racing, especially with the new black carpet release by CRC this season. Pick up a bottle with the chrome dot on the cap!

  • Carpet Foam and Rubber Tire: Apply SXT 3.0 to clean tires. Typically the entire rear tires and a portion of the front tires (starting at the inside edge) are coated, depending on traction conditions. Soak time before wiping is also dictated by traction conditions; longer soak = higher traction. Start by soaking the tires for 15 minutes, timing it so that you wipe them 10 minutes before racing.



SXT 3.0
SXT00030

SXT 3.0 was designed to provide superior performance in a minimum odor environment for both foam and rubber tire racing. It has been engineered, tested and proven to be compatible with Jack tracks. No worries about setup changes when switching compounds as SXT 3.0 provides the same on-track feel and performance as Jack.

Another benefit we have noticed during the year is the ability to rejuvinate old foam tires. In our tests we have taken 1 or 2 year old tires and soaked them a couple times with SXT 3.0 and they tend to come back to "like new". Simply run them once and you have race ready tires that you usually would have toss away!

  • Carpet Foam and Rubber Tire: Apply SXT 3.0 to clean tires. Typically the entire rear tires and a portion of the front tires (starting at the inside edge) are coated, depending on traction conditions. Soak time before wiping is also dictated by traction conditions; longer soak = higher traction. Start by soaking the tires for 15 minutes, timing it so that you wipe them 10 minutes before racing.
  • Asphalt Foam: Apply SXT 3.0 to tires. Typically the entire rear tires and a portion of the front tires (starting at the inside edge) are coated, depending on traction conditions. Apply SXT 2.0 on top of SXT 3.0. Soak the tires for 20 to 30 minutes, timing it so that you wipe them 10 minutes before racing. Shorten soaking time if track is high bite.



SXT 2.0
SXT00020

SXT 2.0 was developed for asphalt rubber tire racing. The natural oils in the rubber are lost due to heat and friction occuring during the course of racing. The high viscosity compound in SXT 2.0 adheres to the tire for long periods as it works to replace these natural oils.

SXT 2.0 has been used successfully in carpet racing as well as asphalt racing.

  • Pre-race Treatment: After cleaning the tire, coat the tire with a thin to moderate film of 2.0 and set aside to soak. The longer the better; 2.0 will not dry up. Tire warmers may be used. Prior to your race, wipe the tires very well with a clean rag. The tire surface should feel slightly tacky when you drag your finger across the surface. If there is still an oily feel, wipe some more.
  • Maximum Asphalt Treatment: Clean tire with SXT 1.0. Coat tire with SXT 2.0 for as long as time permits between runs. Tire warmers may be used. Wipe 2.0 off tires and wipe down with SXT 1.0.

 © 2016 JB PRODUCTS LLC | ALL RIGHTS RESERVED